Spent all sodding day fitting this tw4t of a thing. If anyone is thinking of getting one......forget it LOL So tight to everything. Glad it's on though and am NEVER going to take it off again PMSL
Announcement
Collapse
No announcement yet.
And again LOL
Collapse
X
-
Originally posted by Dave1800BDA View Postgood job james must of been that calming person after school
its on
heated brake fluid could be a concern tho
Yeah, Heated fluid, Heated clutch cable, Heated paint is all a worry I think some heat shielding will be needed.
Comment
-
Originally posted by RS2K View PostShould have got one that fits right.....:winka: wot a ****
Comment
-
-
looking good kev.
Are you still going to run the servo and tower? if yes you will need to cut a section out of the tower to fit past the exhaust, I also had to grind back the pushrod linkage in the tower as it touched my exhaust.
You will need to wrap the clutch cable and route in a way to clear now and yes you will need heat protection on your brake pipes and floor pan now
Comment
-
Originally posted by Dave1800BDA View Postpmsl got you going then
Originally posted by hotrs2000 View Postlooking good kev.
Are you still going to run the servo and tower? if yes you will need to cut a section out of the tower to fit past the exhaust, I also had to grind back the pushrod linkage in the tower as it touched my exhaust.
You will need to wrap the clutch cable and route in a way to clear now and yes you will need heat protection on your brake pipes and floor pan now
Comment
-
-
Originally posted by Frosticles View PostAm going to see what the tower does as I would like to keep it. Glad I didn't fit the manifold whilst it was in place..... Daft question but where can I get heat shielding from?
Comment
-
Originally posted by graham John View Postyes watch out for that kev, you will get brake fade whilst out on track and before you know it you will be in the gravel.....................AGAIN
cheeRS
Many thanks for all your replies
Comment
Comment