The part holding the job up was the exhaust. I initially had a Janspeed manifold and system on the car, so since I have gone to standard manifold and downpipe I was hunting around for a standard system to prevent butchering the Janspeed system up
Change of plan .....Dale got his angle grinder and welder out today and did a great job. He welded the Janspeed system to the downpipe and cut out the middle box and welded in a straight pipe.
Also done this afternoon was fit the cables to the pedal box, fill up with water, and put brake fluid in. I was a bit aprehensive about this with visions of brake fluid squirting all over the new paint. Alas, all went well
The start-up will be tomorrow, so watch this space Dale is confident, but I am not
the janspeed joins upto a std manifold anyway aled ???
It's the flange that was the problem and as the last 1/4 inch of the downpipe was see-through , it was cut off and the Janspeed was connected via with a bracket. It was the other end which was welded to eliminate the middle box.
Comment