not now I have'nt gra
Announcement
Collapse
No announcement yet.
FAO Mogs, Hally, Troll, 191964
Collapse
X
-
Originally posted by Banishit View Postnot now I have'nt gra
cos the postman was knocking at my door at 7.30 this morning with them all
so after work I psyched myself up and went down the garage with the cutting gear
so far so good
EEEeeeek
a needle file here and there, I intentially used a cutter 2mm under size as they have a tendancy to wander, but I measured with a vernier after the cut and it was witin 0.10mm
more 'oles
spare parts
all donecrap pic as I didnt finish till 11.30 this evening
all in all it's pretty easy fitting them, I translated the German fitting instructions that I'll give out with the locks, the worse part is setting the heights and getting them all adjusted, just takes time
anyway I'm chuffedand a massive thanks to Brian for sorting them out
Cheers Glyn
Comment
-
Originally posted by Banishit View Postthey look superb Glyn, well done nicely done,
BTW Glyn what screws did you get to fit the retainers ? length/ thread type ?you will need,
2 off std pitch M4 x12 2 off for the lock retaining rings
2 off M6 x 20 bolts to go in the top of the locking plates
2 off large M6 washers for going under the slam panel
2 off M6 nylocks for going under the slam panel
1 off tube of clear silicon sealant,
1 off 24mm hole cutter,
1 off 78mm hole cutter
1 off 6.5mm Diameter drill
1 off touch up stick in body colour for doing inside the cut holes
3 off cans of strongbow (this is my particular favourite brand other more intoxicating products are available)
some copper grease, some threadlock
and a very steady hand
hope it helps
Cheers Glyn
Comment
Comment