Tweet
Originally posted by merp0
View Post
I've barely scratched the surface yet 
-
I did not think that you had done too bad as I see that you have lowered it! ;-)
-
Come on Mate this should be fininshed by nowOriginally posted by merp0 View PostDifficult roads often lead to beautiful placesComment
-
It’s only been 2 years 😁Comment
-
I've got a few big piles of parts, but still no car
but its finally starting to get some new metal
Sill closing panel was a bit squashed, so made a new bit and welded it in.
Using the whole lower quarter repair panel to remove as much rot as possible.
but it takes a fair bit of fettling.
Getting in to the arch.
Tacking it all in to place.
Starting to look like a quarter panel
Comment
-
Axle off, I thought it would put up a fight, but it wasn’t too bad.
Time to repair the inner edge of the wheel housing.
Finally got a wheel well
Comment
-
Good stuffComment
-
-
Good to see some progress
Comment
-
Round the back.
Chassis missing it’s end
And then not
Back edge of the boot floor is a bit frilly, so time to make s new bit.
And welded in.
Chassis end plates.
Lower rear panel ready to weld.
Last few holes
Does my bumper look big in this.
Comment
-
Getting there young man.
Difficult roads often lead to beautiful placesComment
-
-
-
Comment