The Black Beauty

[Andyc]

you are off ya head matey tops that

[grum]

you are off ya head matey tops that

............... , not me fella, just say NO !

[graham John]

............... , not me fella, just say NO !

cheeRS

[graham John]

bought this on the weekend, hopefully help the performance (and Starting )





any advice / tricks to look for when fitting it ?


cheeRS

[grum]

you wanna hand fitting it

[Andyc]

you wanna hand fitting it

NOOOOOOOOOOOOOOOOO

[taffr]

you wanna hand fitting it

you can do mine grum

[grum]

cheers Taffr - glad someone has confidence in me ........................................ u sure ?

[taffr]

cheers Taffr - glad someone has confidence in me ........................................ u sure ?

i don't believe all the bullshit about you son

[graham John]

you wanna hand fitting it

cheeRS

[Miniliteman]

Nice kit sir, money well spend.
There should be some instructions in the box but make sure you use proper crimping tools for the wires of the 3-pin connector after (!) you put the rubbery (waterproof) bits on the wires.
If you haven't fitted one of these before have a good look how to fit the chopper on the dizzy-shaft. Set engine to TDC, remove dizzy, fit optical eye and make sure that the chopper just passes the eye when the dizzy is in the engine again. (shaft turns when putting dizzy in).
Good luck, Leon.

[lee bishop]

what are the advantages of this set up over the aldon type that sits within the dizzy cap - apologies in advance if this is a silly question

[Miniliteman]

what are the advantages of this set up over the aldon type that sits within the dizzy cap - apologies in advance if this is a silly question

Apologies accepted

Aldon ignition is very good also, but it is in the dizzy so any vibration of the engine is subjected to the module as well. Plus the Lumenition one has a bigger case to absorb heat generated by the electronics (transistor switching the current).
The Ignitor I is just a switching transistor, the Ignitor II is similar to the Performance Lumenition kit in having controlled dwell and current-controlled-output.
Apologies in advance if this is too technical.

[richy c]

mount it all on an alloy plate, looks better than just screwing onto the inner wing

[graham John]

Nice kit sir, money well spend.
There should be some instructions in the box but make sure you use proper crimping tools for the wires of the 3-pin connector after (!) you put the rubbery (waterproof) bits on the wires.
If you haven't fitted one of these before have a good look how to fit the chopper on the dizzy-shaft. Set engine to TDC, remove dizzy, fit optical eye and make sure that the chopper just passes the eye when the dizzy is in the engine again. (shaft turns when putting dizzy in).
Good luck, Leon.

thanks Leon, after having so much 'conflicting' advice i decided to stick with what i know about best, also thanks for the fitting tips

was a few ££££ but im sure it will be worth it

cheeRS