Ruddys Resto Corner 'Again'

[RUDDY]

Finished up on the drivers D panel today , a bit of red oxide primer to keep the tinworm at bay for now. Have ordered a new Gen Ford front chassis leg from Kev Curtiss , so until that arrives I will be getting on with the D panel on the passenger side.

[Banishit]

lovely finish there Ruddy nice quality work

[GAZ W]

This car looks likeit is gonna be very nice when its done

[RUDDY]

Just in case you lot thought I had given up , I have been waiting for a few parts to arrive and a break in the Cumbrian weather . Today I have mainly been trial fitting this.....


Before fitting it permanently there are few small repairs to make to the lower bulkhead , then I can get the chassis leg and inner tacked into place and move onto the passenger side. I have decided to replace the rad supports and crossmember as well, also the slam panel. This is getting expensive..........
cheers, Paul

[Banishit]

another top Job

[paul spence]

Nice to see its still going ,will it be ready for your show Paul?
or am i being a !

[RUDDY]

Yes Paul it will be ready for the show......in 2007.....funds allowing !!!

[RS2000&MEXICO]

looks good m8 thats some top work there...hope it all goes well.

[vinny]

well played ruddy as they say

[Frosticles]

Coming along nicely there, Will be a stunner I'm sure

[lee bishop]

whats happening rude boy?? any more pics???????????

[RUDDY]

Just thought I would pop this up in case you gents thought I had given up.
One chassis leg and inner wing fitted , passenger side inner wing 90% removed , then mam said it was time to come in for tea (the wife said get out of the garage !!)

[RUDDY]

Latest pics , n/s inner trial fitted along with RS front x-member assembly as supplied by Mr Hoarder. Hopefully these will be welded in over the next week or so. I will then complete the n/s D panel and replace the holy bulkhead plenum then get the front end etch primed and bubble wrapped before moving onto the floorpans.

[Banishit]

lots of panels going in there nice

[Frosticles]

Nice use of a sealing gun there :bom: