whats in your engine???

[pockets]

my pinto has a kentcams RL30 "stock/hotrod" camshaft in it, Ive got no problems with it but Ive just never heard of anyone else using the same cam as me.

has anyone else heard anything about it or know why no ones using it much??


if not:-

what cam/s are in your engine????

[CHELT RS]

I opted for a BF 134 high torque cam from Burtons built into a stage 3 head and 45 Webers all on a 2.1 block. Should go quite well when I finish building it.
cheRS
Phil.

[Darran]

pinto

Im using a kent cams "HT2",Good for loads of revs and high peak power

[RS2000&MEXICO]

seized no 3 piston

[76mex]

just general wnak lagging behind bits

[Dave1800BDA]

seized no 3 piston

lol

2 x BD3s and 1 x 1600cc gt cam

[RS2000CUSTOM]

Kent Cams RL31

[lee bishop]

newman phase 3

[TimGR]

Crossflow with a Holbay 658 cam. Nothing much happens below 4,000 rpm.

[Dingy]

BD16e x2

[Miniliteman]

my pinto has a kentcams RL30 "stock/hotrod" camshaft in it,
has anyone else heard anything about it or know why no ones using it much??
if not:-
what cam/s are in your engine????

Pockets,

there is a large choice in high-lift cams with moderate duration (300 - 310 degrees), I believe they all are very close to the old Kent RL2 and the Burton BF63.

I have two L14's and half a 1600GT cam (steel).

[Frosticles]

Kent Cams RL31 Vulcan Maxiflow 2 head stupidly big valves twin 45 weber's Lots of fun.

[richie]

bhp

Kent Cams RL31 Vulcan Maxiflow 2 head stupidly big valves twin 45 weber's Lots of fun.

what power is it m8.
i bet its lagging behind the rs2s.

[pockets]

what power is it m8.
i bet its lagging behind the rs2s.

yea mine too!