It's All About the Base, No Trouble ;)

[merp0]

Axle off, I thought it would put up a fight, but it wasn’t too bad.




Time to repair the inner edge of the wheel housing.












Finally got a wheel well

[merp0]

I've got a few big piles of parts, but still no car





but its finally starting to get some new metal





Sill closing panel was a bit squashed, so made a new bit and welded it in.





Using the whole lower quarter repair panel to remove as much rot as possible.



but it takes a fair bit of fettling.





Getting in to the arch.





Tacking it all in to place.




Starting to look like a quarter panel

[merp0]

It’s only been 2 years 😁

[Andyc]

https://www.youtube.com/watch?v=N5CM...&feature=share

Come on Mate this should be fininshed by now

[merp0]

https://www.youtube.com/watch?v=N5CM7k0l9fY&feature=share

[RS2000EXPRESS]

I've barely scratched the surface yet

I did not think that you had done too bad as I see that you have lowered it! ;-)

[merp0]

I've barely scratched the surface yet

[Andyc]

Aint you finished this yet

[merp0]

A tiny bit more done

[merp0]

Ha ha, you can't rush a good thing, as you well know.

[vlv991v]

I'll update it when ever I get bits done, but there might be some long gaps

Shaking my head. Some people!

[seanyboy]

It was good to see you again too, and GUF, but I don't think I'll be parking mine next to it for a good while



Correct looking Centre caps are a must.
Try these for size, with some paint and a sticker

https://www.ebay.co.uk/itm/182185182606

This is a finished listing, just as an example, keep your eyes open and you'll get some in reasonable condition.

I'll keep my eyes open for them

[seanyboy]

Go on fit then, everyone has fishnets and alloys!!
Mind you black centre caps for steels might be hard to come by unless you've already got them!

Unfortunately not, I have heard they are quite rare, hopefully a set will turn up!

[merp0]

Good luck with it - looks a really good project, I bet you could have that done for Bodellwydan next year! Good to see you again yesterday (personally I'd keep it as close to standard as poss!)
Cheers - Andy (GUF)

It was good to see you again too, and GUF, but I don't think I'll be parking mine next to it for a good while

Go on fit then, everyone has fishnets and alloys!!
Mind you black centre caps for steels might be hard to come by unless you've already got them!

Correct looking Centre caps are a must.
Try these for size, with some paint and a sticker

https://www.ebay.co.uk/itm/182185182606

This is a finished listing, just as an example, keep your eyes open and you'll get some in reasonable condition.

[ebj60t]

Go on fit then, everyone has fishnets and alloys!!
Mind you black centre caps for steels might be hard to come by unless you've already got them!