ALANS MK1 ESCORT

[GraemeJ]

I guess I will need to repipe the fuel line as it looks like it has been done in copper breke pipe
The plan is to run new steel braided pipe through the car so what will be the best bore to use ?

Guess you need to see what fittings you get with pump and regulator and go from there. Id say they will most likely be 8mm

[paprst]

wow !!!!


Very nice m8 ! Enjoy it!

[alancdavis]

.

[alancdavis]

I guess I will need to repipe the fuel line as it looks like it has been done in copper breke pipe
The plan is to run new steel braided pipe through the car so what will be the best bore to use ?

[GraemeJ]

My zetec ran 45 webers Alan and ran fine up to 180bhp for 3 years, with a single red top Facet pump in the boot, and i then had a filter king regulator under the bonnet.

This will be fine.

[alancdavis]

Could do with advice as to the best fuel pump set up for my Zetec running twin 45 webbers

Thought of twin pumps in parrellel to actas a back up and move the filter and pressure reg from under the bonnet to the boot

Any advice will be welcome

[alancdavis]

I was wondering if the Mexico stripes fit ok over the bubble arches ? or does it distort them ??

[alancdavis]

who do you work for over in kazakstan alan, thats 3 of us on here!!

Worked for TCO / Areva out in Tengiz,,,,,,, Project is now over but looking for something else out there.

My wife is Kazak so recent trips back are family visits and Vodka restoc k

[alancdavis]

Not a lot done recently but a little progress made



Underside pressure washed and coat of stone cip ans two coats of underseal applied




Floors cleaned and coat of metal primer




New dash panel sat in place to see if fit is ok




New wheels fitted and splash of blue paint before the final choice of colour is made


Need to start on the interior next

[LOUIE]

who do you work for over in kazakstan alan, thats 3 of us on here!!

[fast eddie]

looking great, now get some paint on it!

[Aled]

What colour is it going to be Alan ?

[alancdavis]

Yukspeed fit the arches and MG of york blended them in

[sidney]

Nice job on the arches, mines still dreaming!! did you blend them in yourself?

[alancdavis]

Can you still get full sets of rubber mats for the MK1s,,,not the aftermarket floor mats only ??
I think I mean the moulded type