Restoration op Zebra

[graham John]

lol




but happy to put condom on his hands


cheeRS

[Frosticles]

That looks like you've cut far too much off are you sure you measured it properly??

[graham John]

That looks like you've cut far too much off are you sure you measured it properly??

cheeRS

[Frosticles]

cheeRS

No he wasn't wearing any "Protective" glasses G

[Frosticles]

Are you any good with a welder cos looks like you will need to use one son,,PMSL.(RoddeRS)

[Andyc]

Tes chaps cut the right lenght but now i have to grind the splines back as they hit the rear of the crank and it will not do up to the block(2.8 SPLINES ARE 10MM LONGER)

[RS2kSX]

good luck Andy...
get some glasses

[Andyc]

here you go chaps does this look better




It is 144mm from the face to the end

[grum]

bit too much off now Andy

[paul andrews]

you crazy ****er,that should be well balanced now m8.nutcase

[taffr]

you crazy ****er,that should be well balanced now m8.nutcase

does it matter on the recovery truck

[Tongy]

NOW YOU MAKE SURE ALL IS LOCTITED AND WIRED AND GUM SHIELD ON THE READY .

ON THE PLUS SIDE NO CHANCE OF YOU FALLING ASLEEP AT THE WHEEL NOW MANDY

[taffr]

i feel so sorry for the spigot bearing, it'll be like a hula hoop in no time

[Andyc]

Well took the box to pieces to get the in put shaft machined and did a few mods whilst it was apart






Drilled the main oil feed to 12 mm






shaft now done


New bearing coming tomorrow as the front one was ****ed.All new oil seals and drain plug fitted so now like new

[wetandwindy2]

did you do all this yourself Andy was it easy to do