Mk1 Fiesta Zetec - Project Welsh & Proud

[WelshRS]

looking good chris, another piece of the jigsaw in place, get your brushes out, i'll have a job for you soon

Gonna need to get some practice in i think been a while

[WelshRS]

These turned up today, with all the linkages, cable, manifold etc

need a starter motor and alternator next and finish the wiring, only fuel
tank and lines after that and i can try and start it

Chris

[taffr]

shineeeeeeeeeeeeeeeee

[Andyc]

lush

[ASHLEY]

Very nice ....

[TimGR]

Car looks spot on. Well done.

[SHIFTY]

Very nice this

[havard01]

Any updates on the Fiesta Chris?

[fast eddie]

Any updates on the Fiesta Chris?

yer, come on!!!!!!!!!!!!!!!

[WelshRS]

Sorry Peeps

been a crazy few weeks at work so its taken my eye of, but i have been busy buying a few bits n pieces, gonna go into work tom to sort a few bits out so might get some photos up tom, been waiting on some carbon fibre so i can face the escort console once that comes i can fit the switches and start wiring that up

Chris

[havard01]

Where did you get the carbon fibre from Chris?

[WelshRS]

Where did you get the carbon fibre from Chris?

bought from a a company on the internet but they were taking too long to deliver it 6 weeks so i cancelled it and ordered some from CarbonMods not cheap but worth it, i want to get some more for the door cards but performance-trim who used to do them ready cut for the vehicles has gone bust so need to find a cheaper alternative instead

Chris

[WelshRS]

Couldnt wait to get into work this morning to do a bit of wiring on the fiesta got the megajolt all wired up just the connector for the coil pack to crimp, going in again tom to earth the block fit the exhaust and inlet gasket for the carbs sort the map sensor tubing out, fill it with oil and fingers crossed the car should crank over and if i wire up / plumb the fuel pump/reg the it should possibly fire

video of the dash when powered up

[paul andrews]

Looking great bud.top build this and can't wait to see it. Where did you all you labels for the wiring,relay holders etc please

[WelshRS]

Looking great bud.top build this and can't wait to see it. Where did you all you labels for the wiring,relay holders etc please

got the relay holders from Vehicle Wiring - not the cheapest of things, bought 2 relay(8) holders and 1 fuse(16) holder they all just click together.... you do have to crimp each terminal and click it into place

the labeling i make myself do it as i went along, im a signmaker by trade so i have a 20k machine to print small labels lol lot more wiring yet to do i didnt realise there was so much.

if you want some stickers just gimme a list

got the focus rs mk1 starter button working and the starter cranking today so a step closer..... also got the air horns working

Chris