Tweet
Get cracking. Get it done for the Lakes Tour 2007.
-
-
Scuttle panel and heater bowl in and trial fit of wing,door,front panel and slam panel. Work started on drivers side, it needs front and rear floor sections, splash shield and inner and outer a post panels along with inner and outer sills.
Comment
-
few more pics showing the work on the n/side floor.
Comment
-
thats a job looking well done there m8....keep up the good work...
sigpiccheeRS
paulComment
-
well done keep it upComment
-
coming on nicely will be lovely when done
Comment
-
cracking work m8,keep at it bud
sigpicComment
-
added a few more pics
Comment
-
coming along now,stunning work
Comment
-
doors, boot and bonnet after being dipped, pictures are not too clear but the finish after e-coating is very good, well impressed. Exposed a lot of dents where filler has been on the doors and boot and a bit of rot on the bottom edge of the passenger door.
Comment
-
Might have to get my doors done.....How much does this dipping cost?? Cheers, Kev.Comment
-
Coming along well there
Don't fall off your bike.... It Hurts
Comment
-
110 per panel for dipping and e-coating if the panels go in with a shell. Dont know how much it would be for just doing the panels, but i dont see why they couldnt dip your doors with someone elses shell. Think its just over a grand to get a shell done.Originally posted by Frosticles View PostComment
-
coming along well,keep up the good work
sigpicComment
-
my bonnet needs doing like this, anyone in south wales do it ?Originally posted by Frosticles View Post
cheeRSsigpicComment
Comment