Ruddy's RS1600i

[RUDDY]

Well gents work continues , had the underside fully prepped , etched and now it is finished in Dove Grey . Need to add the flashes of red and black overspray that were present from the production line but I may leave that until it comes back from the full respray (as they may overspray everything anyway ) . Just got to make a frame up to roll it about on to get it to the painter.

[Banishit]

not a lot wrong with that un Rud very nice

[Frosticles]

Good job your doing there Mr R. Not bad for a roller skate

[Miniliteman]

STOP STOP STOP STOP !!

Not too late to 5-link it Paul & fit an Atlas axle and a BDT
Just have to make a bit of room for the prop.

[Dave1800BDA]

very nice paul, looks a superb shell that, totally agree with Leon though

[Miniliteman]

very nice paul, looks a superb shell that, totally agree with Leon though

That's unanimous (or something like that) then!

[RUDDY]

On a dolly now and hopefully off to the paintshop next week

[76mex]

nice job ruddy but dont get it 2 shiny or the gimp will be telling mr fuller its 2 shiny to enter into concours

[GAZ W]

Thats looking mint is that ruddy ...top job so far

[ian parker]

very VERY nice

[RUDDY]

Skater shell should be back end of next week (sounding like GJ there ) , in anticipation I have been handing wods of cash to the local platers and powder coaters.

[ian parker]

very very nice Paul, great detail

[Banishit]

very nice looking gear there paul

[RUDDY]

Will be fitting these to the brackets on completion , new proper fogs and spots , cost an arm and a leg

[vinny]

lookin good paul