What goes in Here Size wise ?

[Banishit]

I need to find out what bolt goes in this hole on the water pump 8 mm fits but threads not right about an 1" long

cheers
Dad

http://www.redslate.co.uk/upload/pics/waterpbn.jpg

[GAZ W]

i could tell you what COULDNT go in there size wise :geek:

[Blower]

from memory ,

not very buffty but ... ( group 4 boys do it in the forest )

a piece of pipe, 3 inch long, with a snug fitting bolt shoved in to blank end

and ...

like you say 8mm bolt .. with a few shiny clamps :cyclops:

[Roger Miller]

brian,

I just checked a block.

Its 10 mm iso metric [std metric thread]

However.....

Length wise be very careful.
Its a blind hole.

There wasnt any thread for 4 to 5mm in the hole and if u put to long a bolt in it will break the block.

Make sure there is no silicone in hole, either.
So might be best to take off und check it carefully.

Now
Thats an aftermarket WP.
See they hang alt adjuster off of lug ear. Depending on which alt brkt u got it will snap it off sooner or later.
http://www.redslate.co.uk/upload/pics/water-pump-2-liter-aftermkt-alloy.JPG

Also
The Ford one has a full impeller, which resists cavitation than that one.
http://www.redslate.co.uk/upload/pics/water-pump-2-liter-Ford-Castiron.JPG

[arron]

Heed the Oz's warning Brian as I once broke off that same bolt in that same hole when it bottomed out - cost me £500 for a new GP1 block.

[Banishit]

cheers for that fellas

this aftermarket one has a full impellar also, but yes has a mounting ear too, I just need to find the bolt as its gone walk about