Engine bay in bits again allready

[GAZ W]

Well only the servo and master cylinder

Decided to take off the servo to repaint it after brake fluid has dripped down it from the leaking reservoir cap . and also replacing the rear brake line again after i measured the last new one 5 inches too short , which made me have to route it all wrong and was running dangerously close to the exhaust manifold .

so after about 4 weeks of getting the engine bay finished it is in bits again :geek: :geek:

[Banishit]

you have too much time and money LOL

[GAZ W]

Ahh these are cheap fixes though only going to cost a few quid for the new brake line and paint for the servo

[arron]

Gaz, when I did my engine bay, I gave the servo to the same people who powder coated all my other bits and pieces. They plugged all the holes, sand blasted it and painted it 2 pack satin black. It looks the business and only cost me £15 including having the mounting bracket powder coated. You might want to consider this whilst you've got it off.

[GAZ W]

I considered this last time it was off , but was warned against having it done because of the internals , someone was saying because of the heat that is generated during powder coating it would **** up the seals inside

[GAZ W]

Ahh just re read it ....you had it painted :geek: :geek: :geek: :geek: :geek: